Siemens DH04101 Gebrauchsanleitung Seite 13

II.
Wall mounting
Secure the appliance using the installation tem-
plate, screws and wall plugs so that it is vertical
and flush against the wall:
1. Locate the appliance on the screw and
press down.
2. Screw in the second screw through the
mounting tab and tighten.
DH05101, DH06101, DH06111: For an exposed
electrical connection, the different methods of
routing the supply line found on the assembly
template must be observed.
DH05101, DH06101, DH06111: The sleeve must
fit tightly round the connection cable. If the
sleeve is damaged during installation, the holes
must be sealed water-tight.
III.
Water connection
A Pressurised connection
B Depressurised connection
Fit the jet regulator supplied.
Check the inserted filter and sleeve in the water
inlet.
Ensure that the connection pipes are fitted to the
adapter along the axis of the pipes.
Tighten the union nuts firmly to the adapter with
an open-jawed spanner.
The T-piece and flexible connecting hose (for pres-
surised connection) are available from a specialist
store.
For a depressurised connection, a depressurised fit-
ting must be used, e.g. fitting BZ13051 which can
be obtained as a special accessory.
en
IV.
Electrical connection
C Flow switch
D Temperature limiter
DH04101: Connect the appliance to the mains.
DH05101, DH06101, DH06111
The installation of non plug-in ready appliances
must be undertaken by the respective utility opera-
tor or by a qualified specialist company, who can
also assist you when you are requesting the ap-
proval of the utility company for installation of the
appliance.
The appliances must be connected with a NYM-J3x4
2
(mm ) mains lead. Leads with a larger cross-section
must not be used.
Connect the appliance in accordance with the
connection diagram on the strip terminal.
Screw the housing cover back on.
After installation, give the user the operating
instructions and explain how the appliance
works.
13