Sungrow AW-AM510-I Kurzanleitung Zur Installation Seite 2

EN
This document will be updated from time to time due to updates of the product or other reasons. Under no circumstances
should this document be taken as a substitute for the user manual and the safety instructions provided on the product.
Before performing any operation, please read through carefully the user manual and relevant standards and specifications.
You can find the related documents by visiting http://support.sungrowpower.com/ , or by scanning the QR code provided on
the device or back cover of this Quick Installation Guide.
Operations on the device must only be performed by qualified technical persons. The qualified technical persons must have
received specialized training, read through the user manual to gain a good understanding of the relevant safe operation
instructions, and be familiar with the applicable local standards and safety code for electrical systems.
Before installation, check the delivered items for quantity according to the packing list and see if the delivery matches the
order you placed. Meanwhile, inspect the items for any visible damage. Contact the transport service provider or SUNGROW
in case of anything abnormal.
The cables used must all be intact and well-insulated. Be sure to use insulated tools and wear personal protective equipment
properly during operation.
Violation of any of the above requirements may result in personal injury or device damage.
Safety Disclaimer
SUNGROW shall not be held liable for any personal injury or device damage arising from device-related operations that are not
carried out in compliance with the requirements specified in this document or the user manual.
EBOHFS
Do not touch the contact inside the charging connector when it is powered on.
Electrical connection must be performed by qualified personnel who wear personal protective equipment.
All electrical connections must be done in compliance with the applicable local and national electrical standards.
Be sure to use specialized insulated tools when performing electrical connection.
Do not use the charger when its charging connector or cable is defective, frayed, cracked, or in case of exposed wires.
Contact SUNGROW if you have found any of the above issues.
When the charger is running, do not touch any of its live parts or remove any of its part or component; otherwise, it may lead
to electrical shocks.
XBSJOH
All safety signs and warning labels and the nameplate on the charger must be clearly visible and cannot be removed or
covered.
DBVUJPO
Burn hazard!
During the charging process, do not touch any hot part of the charger (e.g., air outlet for heat dissipation); otherwise, it may
cause burns.
OPUJDF
Non-qualified personnel are forbidden from disassembling the device or moving its components.
Do no install the device in a place with corrosives such as corrosive gas and organic solvent, etc.
Do not install the device in dusty and smoky environments.
Marks on the Product
Disconnect the device from all the external
power sources before maintenance!
Danger to life due to high voltages!
Only qualified technical persons can install and
operate the device.
CE mark of conformity.
EU/EEA Importer.
UKCA mark of conformity.
Do not touch live parts until 10 minutes after disconnection from the sources.
Burn hazard due to the hot surface
that may exceed 60－!
Do not dispose of the device together with
household waste.
Read the user manual before performing any
operation on the device.
TÜV mark of conformity.