Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Select operating mode
■
Use the "Drill/hammer drill" switch
the operating mode of the power tool .
NOTE
►
Change the mode only when power tool is
switched off . Otherwise, the tool could be
damaged .
♦
To change the operating mode, turn the "Drill/
hammer drill" switch
Hammer drilling = Hammer ON
Drilling/screwing = Hammer OFF
Setting the rotation direction
NOTE
►
Operate the rotation direction switch
when the appliance is at a standstill .
■
You can use the rotation direction switch
change the direction of rotation of the power
tool . This is not possible, however, while the on/
off switch
is pressed in .
Clockwise:
♦
For drilling and screwing in screws, turn the
rotation direction switch
as the stop .
♦
Anti-clockwise:
♦
For undoing and removing screws and nuts, turn
the rotation direction switch
far as the stop .
Switching on/off
Switching on:
♦
To start the power tool, press the on/off switch
and keep it pressed in .
■
The lamp
lights up when the on/off switch
is pushed in slightly or fully and illuminates the
working area in low light conditions .
■
8
│
GB │ IE │ NI │ CY
to select
to the desired position .
only
to
to the left as far
to the right as
Switching off:
♦
To switch off the power tool, let go of the on/
off switch
.
■
At low temperatures, the power tool will only
reach its full hammer performance/strike power
after a certain time .
■
To save energy, do not switch the power tool
on unless you plan to use it .
Set drill/hammer speed
■
You can infinitely adjust the drill/hammer speed
of the switched on power tool, depending on
how far the on/off switch
Pressing the on/off switch
low drill/hammer speed . Increasing pressure
increases the speed .
Run-on brake:
■
When you release the on/off switch
brake stops the chuck and prevents run-on of
the tool .
Maintenance and cleaning
WARNING! RISK OF INJURY! Always
switch the appliance off and remove
the battery before carrying out any
work on the appliance.
■
The cordless hammer drill is maintenance-free .
■
Use a soft, dry cloth to clean the housing .
■
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly . The optimum charge level is
between 50% and 80% . The optimum storage
environment is cool and dry .
NOTE
►
Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline .
is pressed in .
lightly yields a
, the
PABH 20-Li B2
Werbung
