XXL Hot Air Frying Machine
7. If the rotating basket, grill skewer or
skewers with the holder are used, touch
the symbol
function.
L
Until you are properly familiar with
the device, the condition of the food
should be checked in between times
to ensure that it does not burn.
8. Once the set cooking time has elapsed,
the symbols on the control panel go
out (exception:
tinues to run for a few more seconds.
A beep is then heard and the device is
in standby mode.
9. Open the door, remove the cooked food
from the cooking chamber and place it
down on a heat-resistant surface.
If you are using the rotating basket, grill
skewer or the skewers, use the removal
tool (10) (see the "Accessories" chapter).
10. Disconnect the device from the mains
power.
11. Clean the used accessory after it has
cooled down (see the "Cleaning and
Storage" chapter).
Briefly Pausing the Cooking Process
If the cooking process needs to be inter-
rupted, touch the
the door (3).
The cooking process is interrupted and the
symbol
flashes.
To resume the cooking process, close the
door and touch the symbol
Ending the Cooking Process
Prematurely
To end the cooking process before the set
cooking time has elapsed, touch the symbol
(20) and hold it.
The symbols on the control panel (1)
(exception:
is heard. The fan may continue to run for
a few more seconds. The device is then in
standby mode.
13606_Inlay_de-en-fr-nl_A5_V2.indb 23
13606_Inlay_de-en-fr-nl_A5_V2.indb 23
(18) to start the rotating
symbol). The fan con-
symbol (21) or open
.
symbol) go out and a beep
CLEANING AND STORAGE
Please Note!
■
Allow the device to cool down com-
pletely before cleaning it.
■
Never spray hot water onto the hot ac-
cessories to prevent material damage.
■
Do not use any sharp or abrasive clean-
ing agents or cleaning pads to clean the
device. These may damage the surfaces.
1. Wipe down the outside of the device and
the door (3), the cooking chamber (4)
and the heating element with a clean,
damp cloth if necessary. Do not clean in
the dishwasher or immerse in water!
2. Clean the used accessories with detergent
and warm water or in the dishwasher.
To maintain the quality of the parts for
as long as possible, they should prefera-
bly be rinsed by hand.
In the case of stubborn dirt, soak in
warm water and detergent beforehand.
3. Allow all parts to dry completely or dry
them off.
4. Store the device in a clean, dry place so
that it is out of the reach of children and
animals.
EN
23
22.03.2024 14:35:51
22.03.2024 14:35:51