Mains Connection; Operation; A) Preparation - Renkforce 1359969 Bedienungsanleitung

d) Mains connection
The mains outlet to which the mains adapter is connected must be easily accessible so that the
mains adapter can be separated from the mains voltage quickly in case of an error.
Do not let the mains cable come into contact with any other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause
potentially fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Before plugging in the mains adapter, ensure that the device voltage indicated at the mains
adapter corresponds to the available mains voltage. Do not connect the mains adapter if the
indication does not correspond to the available mains voltage. Incorrect supply voltage may
lead to irreparable damage to the mains unit or DMX controller and danger to the user.
Make sure that the DMX controller is switched off (put the POWER switch (26) in "O" position)
before connecting it to the power supply.
• Connect the mains adapter connection line to the DMX controller's DC INPUT (25) port.
• Plug the mains adapter into a wall socket.
• The DMX controller is turned on and off at the POWER (26) switch.
Position O: Device off
Position I: Device on

10. Operation

a) Preparation

Effect Light Addresses
The DMX controller assigns starting addresses in steps of 20 to the 12 encodable effect lights. Therefore
also code the starting addresses of your effect lights in steps of 20, because channels cannot be assigned
to the light effects correctly otherwise.
Effect light start address
1
2
3
4
If you assign the same starting address to several light effects, they will act synchronously.
36
effect light
1 5
21 6
41 7
61 8
start address effect light
81
101
121
141
start address
9 161
10 181
11 201
12 221