TOPRO TAURUS E Bedienungsanleitung Seite 8

TOPRO TAURUS can be used inside and outdoors, but only on a levelled surface.
NB: TOPRO TAURUS E must not be used in a damp environment.
Adjusting the forearm support
The forearm supports are adjusted individually. Unscrew the lock underneath the forearm support A until
the cushion is moveable. Place at the required position and tighten the screw. NB If the lock sticks out, it
can be dangerous. Pull the lever down and rotate it so that it doesn't stick out.
Angle adjustment and twisting the handle
(TOPRO TAURUS E-JH / H-JH / M-JH / E-JHB / H-JHB / M-JHB)
Unscrew the screw A until you can move the handle. Adjust the handle B to the required angle, length and
twist and tighten the screw. NB The screw must not be screwed too far out as the parts will fall from each
other. If this happens, then put the pin C in the hole D and E.
See figure 1 for more detailed instructions.
Brakes
(TOPRO TAURUS E-JHB / H-JHB / M-JHB)
Adjusting the brakes.
Unscrew the nut A. Tighten / loosen the brake wire with the adjusting screw B. Make sure the brakes work
properly and don't sweep when brakes are off. Adjust both sides.
Using the parking brakes.
The brake lever C works on both rear wheels simultaneously. Push the brake lever forward. It has some
resistance before it stops and locks both the rear wheels. Pull the brake lever backwards to release the rear
wheels. Inspect the brakes frequently to make sure they work properly.
Using the driving brakes.
The brake lever D works on both rear wheels simultaneously. Pull the brake lever towards you to stop the
rear wheels. When the brake lever is released, the rear wheels are released. Inspect the brakes frequently
by following the information above.
Using the foot brakes
Step on the foot brakes A on the rear wheels or when required on all wheels until you hear a clicking
sound. The wheels are now in a locked position B. To release the wheels, step on the back of the foot
brake pedal so that it comes up again.
Charging the battery
(TOPRO TAURUS E / E-JH / E-JHB)
The battery can not be charged incorrectly. It can be charged at any time without doing any harm. We
recommend the battery to be charged every evening. You will hear a short sound when 50% of the battery's
capacity is used. It will take approximately 6-7 hours to fully charge. To release the battery, press the
release button on top A and pull up. Plug your charger into the wall socket B, and then plug the other end
into the battery's charging point C. To attach the battery again, place it on the hooks on the mounting
bracket D while you steer it down the slot E. Press the battery towards the pile until you hear a clicking
sound. The battery must sit tight and not be movable.
Locking the swing (directional block)
(TOPRO TAURUS E-JHB / H-JHB / M-JHB)
To be done with an index pin A on both wheels. Make sure the mounting bracket for the foot brake is
pointing backwards.
This is how the index pin works.
Locking: Twist the upper part of the index pin B so that it fits into the track of the lower part C. By doing this
the pin D will slide out and lock.
Releasing: Pull the upper part of the index pin B up and turn it 90 degrees. It will then lock in the upper
position. The pin D slides in and the index pin is unlocked.
6