Werbung
Verfügbare Sprachen
Verfügbare Sprachen
◆ Deraileur Guard Installation (4mm Hex Wrench)
Deraileur guard
Step 1:
Remove the bolts on the chainstay.
Step 2:
Put one bolt through the loop on the end of the derailleur guard, and use the
Allen wrench to screw it back into the upper chainstay hole.
Step 3:
Repeat with the other side of the derailleur guard into the lower chainstay hole.
◆ Seat Adjustment
Adjust the Seat Height:
Open the seatpost quick release lever. Adjust the seatpost height by sliding the seatpost
up or down to a height appropriate for your leg length and preferred riding position. Do
not extend the seatpost beyond the minimum insertion marking etched onto the
seatpost.
WARNING:
Overextending the seatpost can cause it to break or come off your
bike, putting you at very high risk of serious injury or death. Avoid this danger by
inserting your seatpost into the seat tube far enough that the minimum insertion
point is no longer visible.
10
Werbung
