ELNA 745 Gebrauchsanleitung Seite 28

H.
Movable Cutting Blade Position
To Disengage Movable Cutting Blade
(down)
Hand turn the flywheel to bring needle bar
to its highest position. Open front and side
covers. Push movable cutting blade
release knob to the right and turn it
towards you.
NOTE: Do not allow the fabric to be sewn
beyond the right side of the needle plate
when sewing any overlock stitch.
(Example: any stitch that uses either R1
or R2 needle position.)
To Engage Movable Cutting Blade (up)
Push movable cutting blade release knob
to the right and turn it away from you.
Example:
5 Thread, 3 Thread Wide and Overlock 3
– engage movable cutting blade (up).
I.
2 Thread Converter
To Engage 2 Thread Converter
Hand turn the flywheel until the upper
looper is in an up position. (HINT: Align
the arrows on the flywheel.)
Lower converter and insert hook into
upper looper.
To Disengage 2 Thread Converter
Hand turn the flywheel until upper
looper is in an up position.
Pull out hook from looper eye and lift
converter up until it secures in far right
position.
Example:
5 Thread, 3 Thread Wide and Overlock 3
– disengage 2 thread converter.
28