Hazet Twin Turbo 9013MTT Betriebsanleitung Seite 16

2. Before starting the
operation
The pneumatic tools must always
be used, inspected and main­
tained in compliance with the
local government, state or federal
regulations.
• Drain the compressor tank and remove the
condensate from the air lines. Carefully read
through the operating instructions for the
compressor.
IMPORTANT:
Use of a HAZET 9070-2 main-
tenance unit is strongly recom-
mended.
CAUTION!
Disconnect the compressed air sup-
ply prior to lubricating, connecting or
disconnecting the tool.
• Oil the tool daily!
• Remove the dust cap
on the compressed air inlet.
• Connect the tool to a hose of suitable size.
Table on page 15.
3. Operation
• Switch on the compressor so that the air
tank can be filled.
• Turn the compressor regulator to approx.
90 PSI or 6.3 bar. The max. working pres-
sure of this tool is approx. 90 PSI or 6.3 bar.
• The power may vary depending on the size
of the air compressor and the volume of the
compressed air output.
• Do not use damaged or worn air hoses or
adapters of inferior quality.
• The technical data provided refer to an
operation of the tool at a pressure of 6.3 bar.
• Caution is required at all times when using
the tool. Negligent operation may cause
damage to the inner parts or the housing
and limit the working performance.
• Press the operating lever to activate the tool.
• Release the operating lever to stop the tool.
• Please note that the tool still carries on
running after the operating lever has been
released.
16
3
Design and function
Always wear personal protective equipment!
^ hazet.com • ] info@hazet.de
The direction of rotation is con-
trolled via the changeover switch
on the rear of the housing; two-
stage forward rotation, single-
stage reverse rotation
• After completing the operation, switch off
the compressor and store it in accordance
with the operating instructions of the com-
pressor.
• Only use clean and dry air at a max. pres-
sure of approx. 90 PSI or 6.3 bar. Dust,
flammable vapour and high humidity can
result in damage to the pneumatic tool's
motor.
• Do not remove any stickers and replace
damaged stickers.
• Keep hands, loose clothing and long hair
away from the tool's moving part.
• Maximum efficiency due to the ground-
breaking HAZET Twin Turbo technology
enables high torques with compact design
• Long service life and high efficiency in
industrial and automotive applications.
• Compact design, optimised for work in
confined spaces
• Innovative 8-blade air motor with 25% high-
er impact performance ensures maximum
torque.
Twin Turbo
2 x exhaust inlet
4 x exhaust outlet