Owner's Liability; Intended Use - Hazet Twin Turbo 9013MTT Betriebsanleitung

1. Owner's liability

• This tool was developed and manufactured
according to the technical norms and stand-
ards valid at the time and is considered to
be operationally reliable. Nevertheless, the
tool may present a danger when it is not
used as intended or used in an inappropri-
ate way by non-qualified personnel. Please
make sure that any person using this tool
or carrying out maintenance work carefully
reads and fully understands these operating
instructions before using the tool.
• Modifications of any kind or any additions
or modifications to the unit are prohibited.
• All safety instructions, warning and opera-
tion notices on the tool must be kept legible
at all times. All damaged labels or stickers
must be replaced immediately.
• All specified installation values or setting
ranges must be observed.
• Keep the operating instructions together
with the tool at all times.
• The tool may only be used if it is in good
working order.
• All safety equipment must always be within
reach and should be checked regularly.
12
2
For your safety
Always wear personal protective equipment!
^ hazet.com • ] info@hazet.de
2. Intended
use
The pneumatic impact wrench 9013MTT has been
designed for loosening and tightening screw con-
nections, e.g. for work on motor vehicles, motor-
cycles, agricultural equipment or assembly lines.
Any deviation from the intended use and/or any
misapplication of the devices is not permitted and
will be considered as improper use. Any claims
against the manufacturer and/or its authorised
agents because of damage caused by improper
use of the devices are void. Any personal injury
or material losses caused by improper use are the
sole responsibility of the owner. In addition to the
safety advice given in these operating instructions,
the general safety regulations, regulations for the
prevention of accidents and regulations for envi-
ronmental protection being valid for the applica-
tion area of this tool set have to be observed and
respected. Use and maintenance of the tool must
always comply with relevant national or federal
regulations.