Hazet Twin Turbo 9013MTT Betriebsanleitung Seite 14

• Do not use the device in an explosive
atmosphere. Pneumatic tools can produce
sparks that may ignite combustible materi-
als. Never operate tools in proximity to
combustible substances like petrol, naphtha
or detergents, etc. Work in well-cleaned and
well-ventilated areas only. Keep combus-
tible materials out of the work area. Never
use oxygen, carbon dioxide or other bottled
gases to power pneumatic tools.
• Do not point the device at another per-
son. Keep children and other persons out of
the work area when operating the tool.
• Do not operate the device in an idle state.
• Do not allow pneumatic tools to come
into contact with sources of electricity.
• Pay attention to the working pressure.
Exceeding the approved maximum working
pressure of tools and accessories can cause
explosions and may result in severe injuries.
The working pressure of the compressed air
must be equal to or less than the approved
pressure load indicated for the tool.
• Check that the hose connection is firmly
seated. Do not use defective pressure
hoses. Uncontrollably moving pressure
hoses may cause severe injuries.
• Only disconnect pneumatic tools when
they are not pressurised. Uncontrollably
moving pressure hoses may cause severe
injuries.
• Use clean and dry air only. Never use oxy-
gen, carbon dioxide or other bottled gases
to power pneumatic tools.
• Only use spare parts, attachments and
accessories which are recommended by
the manufacturer.
• Never carry the tool by the compressed
air hose.
• Never carry the connected tool with a
finger on the operating lever.
• Avoid unintentional operation.
14
2
For your safety
Always wear personal protective equipment!
^ hazet.com • ] info@hazet.de
• Always keep handles dry, clean and free
of grease or oil.
• Make sure that the working area is clean,
well ventilated and always well lit.
• Never use the tool whilst under the influ-
ence of alcohol or drugs.
• Repair work must be carried out exclu-
sively by authorised persons.
• Labels on the tool must always be kept
legible. The user is responsible for ensur-
ing that the sticker stating warning signs,
rotation speed, the serial no. and the
article no. is not damaged and is easy
to read.
• Never use quick-release couplings direct-
ly on the tool. There must be an air hose
of at least 20 cm in length between the
tool and the quick-release coupling.
• Only replace tools when the air hose
is disconnected. Before lubricating or
changing the tools, always disconnect
the machine from the compressed air
supply.
• Use of a maintenance unit (HAZET 9070-2)
is strongly recommended.