Product Description; Use; Installation; Activating Accessories - Cleco Neotek 942396Pt Bedienungsanleitung

1

Product description

As an accessory for NeoTek tools, the Gyroscope allows the angular correction of handheld tools without
support.
Until now, a support has been needed for angle-controlled sequences. As a result, any change in the refer-
ence angle during final tightening, e.g., because of an evasive movement by the worker, should be avoided.
The gyroscope makes such a support unnecessary.
2

Use

Gyroscope
Requirements
NeoTek tool
Software requirements
Note
Note the order of the software updates:
1. Perform controller software update.
2. Perform measurement card firmware update.
3. Perform TIM firmware update.
4. Perform firmware update for accessories.
3

Installation

Note
Before installing, take the tool out of operation or switch off the controller.
30/50/70ESN(...), 30/50/70EAN(...)
• First accessory: see Figure 01, Page 3
• Second accessory (optional): see Figure 02, Page 3
30/50EPN(...)
• First accessory: see Figure 03, Page 4
• Pistol suspension bail (optional): see Figure 04, Page 4
4

Activating accessories

For additional settings, see the particular software documentation for the controller.
Apex Tool Group
942396PT
Order No.
30 Series...
Angle head,
inline
P2407MA | 2019-06
943684PT 943685PT
50 Series... 70 Series...
Angle head, Angle head,
inline inline
Bootloader: S169353-101 or later
Controller: e.g., S168813-1.9 or later
Measurement card: S168025-510 or later
TIM (Tool Interface Module): 3.4
T55- T55-
3000020 3000021
30 Series... 50 Series...
Pistol Pistol
1
EN
9