Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Check whether the POM wheel of the left and right parts of the Y-axis fits
the profile and whether the movement is smooth and there is no jam
Left unit
Eccentric nuts
Note: ① It is the most appropriate position to feel a little friction between the POM
wheel and the profile when rotating the POM wheel.
② If the wheel rotates in the air and does not fit the profile, the eccentric nut can be adjusted clockwise from the direction
of the screw head with an open-end wrench.
3.1 Put the synchronous belt of the carriage on the synchronous wheel
of the X-axis motor
Carriage and lifting module X1
3.2 Push the carriage into the X-axis beam
① The carriage pushes into the side
② The frame seal is at the bottom,
of the X-axis white terminal.
and the cables tobe placed in the seal
①
Rear view
05
Right unit
Eccentric nuts
The teeth of the timing
belt face the timing pulley
③ The wire is between the X-axis beam
and the pom wheel
②
③
3.3 Place the assembled carriage on the machine frame and
hand-tighten the screws, then assemble the tensioner.
The frames to
be aligned
well at slot
3.4 Fixed X-axis beam
Align the X-axis beam
Place the timing
with the slot
belt on the profile
First screw two M4 * 50 screws to fix X axis beam (not too tight, adjust X axis beam parallel)
Attention to the
carriage direction
Check
3.5
for the guide on
tensioner installation.
screw M4*50 x 2
EN
06
Werbung
