Livescribe Paper Tablet Benutzerhandbuch Seite 18

When you hover your smartpen tip on a Tablet Page and then tap to perform a mouse click, the cursor
on your screen may appear to move on the screen (usually downward). This effect is related to the
parallax effect, in which the apparent position of the smartpen tip from your point of view is different
from the point of view of the camera in the smartpen tip. The camera is "seeing" a slightly different set
of coordinates (position on the page) than you are.
In general, to minimize the jumping effect of your cursor, follow these guidelines:
•
Use the largest available notebook for your Tablet Page. Using a larger piece of paper improves the
Paper Tablet resolution.
•
Set your computer's double-click speed to slow.
•
Before tapping, move your smartpen very close to the page.
•
When tapping, hold your smartpen in an upright position, perpendicular to the page surface. Or, if
you are holding your smartpen at an angle, tap by moving your smartpen in the direction of the
smartpen tip at the same angle. This follows the point of view of the smartpen camera.
Right-Clicking
By default, tapping on a page is the same as a left-click on a mouse. To right-click, you can either tap
and hold, or create and use a right-click button:
To right-click using tap and hold:
1.
Hover over an active area of a Tablet Page.
2.
Tap and hold on the page for a few seconds to initiate a right-click command.
To right-click using a right-click button:
™
Livescribe Paper Tablet User Guide
Right-Clicking
14