Livescribe Paper Tablet Benutzerhandbuch Seite 11

T : Optionally, mark your Tablet Page to indicate the page boundaries of your monitor screen. Hover
IP
over the Tablet Page and locate each of the four corners of your monitor screen. Draw a small mark
on the page at each position.
Activate Page Quick Command
You can also use a Quick Command to specify a Tablet Page. This is useful when you are in the
middle of using the Paper Tablet and want to activate to a new Tablet Page.
1.
With no other applications running, draw a horizontal line on your notebook (starting from right or
left) and without removing your smartpen tip from the page, immediately double back on the line
ending close to where you started.
2.
Immediately begin writing the words "activate page" above the line. As you write the first few letters,
look at your smartpen display. If it shows the "activate page" command, double-tap anywhere on
the page to run it. You do not need to finish writing the whole command name.
3.
To activate a Tablet Page, draw a short vertical line (approximately 1 inch or 25 mm) from top to
bottom on the page in the desired orientation, or tap it to accept the default orientation.
™
Livescribe Paper Tablet User Guide
Activating a Tablet Page
7