Tesla RoboStar iQ700 Bedienungsanleitung Seite 17

HEPA FILTER - cleaning 1 time per week
•
Do not clean the HEPA filter with your fingers or a brush, only with a stream of clean water (do not
use cleaning agents) or vacuum it with a conventional vacuum cleaner.
•
Allow the HEPA filter to dry thoroughly, never install a HEPA filter that is wet in a robot vacuum
cleaner!
•
Do not expose the primary filter and HEPA filter to sunlight.
•
Vacuuming with a dirty HEPA filter or without a HEPA filter inserted can damage the robot vacuum
cleaner.
•
We recommend changing the HEPA filter every 6 months.
CENTRAL CLEANING BRUSH AND SIDE CLEANING BRUSH - cleaning 1 time per week
Remove the central cleaning brush by pressing the two tabs on the brush cover. Use the cleaning tool
to remove any hair tangled in the main brush. Keep the center cleaning brush free of large amounts of
hair, dust, cotton, etc. Check the side cleaning brush together with the air intake opening according to
the intensity of the dirt, at least once a week, and remove tangled hair and other dirt.
Front wheel: Use a flathead screwdriver to insert under the rubber wheel and move upwards to remove
it. After cleaning, insert it back in until you hear a click. Also clean the wheel axle.
Floor sensors: once a week, clean the four sensors on the bottom of the robot vacuum cleaner with a
soft, dry cloth. Check that the front bumper, under which the impact sensor is located, is not blocked.