Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To assemble the hood, use the accessories that are supplied and follow the instructions
given in the enclosed handbook.
ELECTRIC WIRING
The electrıc wiring must be performed by a specialized electrician fully respecting current
standards and legislation in force. Check that the power supply corresponds to the voltage
requested by the hood, which is given on the silver label stuck inside the hood. Ensure
that the wiring system conforms to current standards and the earth discharge works
efficiently. Pay special attention to the hood power cable, ensure that it does not pass
through any holes without a cable clamp. For direct connection to the electrical mains is
necessary to provide a device that ensures disconnection from the electrical mains, with an
opening distance of the contacts that allows the complete disconnection under the
conditions of overvoltage category III. in accordance with the rules of installation
The plug or omni polar switch must be accessible when the unit is installed.
If the power cord is damaged, it must be replaced by a special cord or assembly available
from the manufacturer or its service agent. The cable used must be of type H05VV-F3X0.75
mm2 minimum cross-section.
The manufacturer declines all responsibility if the current accident prevention standards
in force are not respected, which are needed for the wiring system to operate correctly
CONTROLS
DIGITAL TOUCH CONTROL
There are five digital touch buttons.
• 4 button for turning and for turning the motor off.
• One button for turning the lights on and off.
USE AND MAINTENANCE
Before beginning any sort of cleaning or maintenance work, turn power off to the hood
Changing the light bulbs
LED bar light replacement should only be carried out by qualified technicians using only
original spare parts. "Figure C"
Cleaning the metal filters:
The metal filters fitted in the hood should be washed every 2-3 weeks, depending on how
much the hood is used, using hot water and a liquid detergent that is not too aggressive.
The metal filters can be removed by the special handle, unhooking the front part of the filter
and pulling it downwards. Check
Electrostatic odor, smell removal system.
Your hood is equipped with a patented odor, smell removal system. As you turn on the
hood the system starts to work with the motor and when you turn off the hood, it stops
simultaneously. For best efficiency, turn on the hood as soon as starting to cook and leave it
working for about 30 minutes (depending on the kitchen size) to remove the odor from your
"Figure A,B"
Werbung
