Input Mode; Reset Function Via Keyboard; Incremental Measurement; Referencing - Siko MA501 Zusatz Zur Originalmontageanleitung

MA501-S

Input mode

7 Input mode

7.1 Reset function via keyboard

Precondition: Parameter 'Reset enable' (ABS ON) in programming mode
NOTICE
must be programmed to "ON" and the display is not in programming mode
• Press key

7.2 Incremental measurement

Precondition: The display is in the normal mode, not in the programming
NOTICE
mode.
• Pressing the
• The display is zeroed and the
• Switching off by pressing the
• While in the incremental measurement mode the display can also be

8 Referencing

The display must always be referenced:
• Before the first use of the measuring system.
• In case of a displacement during power failure (if no backup supply is
During reference the counter is set to the programmed reference value (+
offset value). Thus, the electronic display can be zeroed if both reference
and offset values are 0.

8.1 Manual referencing

Manual referencing is enabled:
• By pressing key
MA501-S · Date 31.03.2017 · Art. No. 82991 · Mod. status 263/16
to reset the display to the reference + offset value.
key switches the display to incremental measurement.
sor travels (or the magnetic ring rotates) the value in the incremental
measurement mode is displayed right-aligned.
ing value is displayed again.
set to zero by pressing key
surement in the background.
connected).
. Therefore menu point 'Release of reset function'
ABS ON must be programmed to ON.
appears bottom left. When the sen-
key once more. The absolute measur-
. This does not change the absolute mea-
English 25