Technical Data; Charging Time - Parkside Pags 20-Li A1 Originalbetriebsanleitung

GB
IE NI

Technical data

Cordless
Combi-Shear ............PAGS 20-Li A1
Motor voltage
U .................... 20 V
Type of battery ................................Li-ion
Rated speed n ...................... 1200 min
0
Sound power level (L
guaranteed ............................... 85 dB
Weight (incl. accessories) approx 1.726 kg
Vibration (a
)
h
at handle ....... ≤ 2,5 m/s
Temperature.......................... max. 50 °C
Charging ............................. 4 - 40 °C
Operation ...........................-20 - 50°C
Storage ................................. 0 - 45°C
For use with smart batteries
(Smart PAPS 204 A1/Smart PAPS 208 A1)
Operating frequency/
Frequency band .... 2400 - 2483.5 MHz
Max. transmission power .......≤ 20 dBm
Grass-trimming blade
Cutting width ..........................120 mm
Sound pressure level
) ....................72.9 dB; K
(L
pA
Sound power level (L
measured ...... 81.4 dB; K
Shrub-trimming blade
Cutting length ........................188 mm
Cutting thickness ..................max.8 mm
Sound pressure level
) ....................72.1 dB, K
(L
pA
Sound power level (L
measured ...... 82.5 dB; K
The noise and vibration levels have been
calculated according to the norms stated in
the conformity statement.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised test
6
(Direct voltage)
)
WA
; K= 1,5 m/s
2
= 3 dB
pA
)
WA
= 2.31 dB
WA
= 3 dB
pA
)
WA
= 2.51 dB
WA
method and can be used to compare one
power tool with another.
The specified total vibration value and the
stated specified noise emission value can
also be used for a provisional assessment
of the load.
Warning: The vibration and noise
-1
emissions may deviate from the
specified values during actual use of the po-
wer tool, depending on how the power tool
is being used and, in particular, what kind
2
of work-piece is being worked on.
Safety measures for the protection of the
operator are to be determined that are ba-
sed on an estimate of the actual vibration
load under the real operating conditions
(for this, all parts of the operating cycle are
to be taken into account, for example, times
in which the power tool is turned off, and
those during which it is turned on but run-
ning without a load).

Charging time

The device is part of the X 20 V TEAM series
from Parkside and can be operated using
batteries of the X 20 V TEAM series from
Parkside.
Batteries of the X 20 V TEAM series from
Parkside may only be charged using
chargers of the X 20 V TEAM series from
Parkside.
We recommend that you operate this appli-
ance with the following batteries only:
PAP 20 B1, PAP 20 B3,
Smart PAPS 204 A1, Smart PAPS 208 A1
We recommend charging these batteries
with the following chargers:
PLG 20 A3, PLG 20 A4, PLG 20 C3,
PDSLG 20 A1, PLG 20 C1,
Smart PLGS 2012 A1