Error Mode; Hand Blender - Philips HR1379/10 Gebrauchsanweisung

EnglisH
8
overheat protection
- If you process a too heavy load, the motor unit may become hot. The
built-in safety system switches off the appliance and the charging light
lights up red.

Error mode

If you press the unlock button longer than 2 seconds, the indicator lights
starts to flash red to indicate that the error mode is activated. If this
happens release all buttons and switch on the appliance again (see step 4, in
chapter 'Using the appliance').
Preparing the food
1 Let hot ingredients cool down before you chop them, blend them or
pour them into the beaker (max. temperature 80°C/175°F).
2 Cut large ingredients into pieces of approximately 2cm before you
process them.
using the appliance

Hand blender

Avoid touching the blades, especially when the blender bar is attached to
the motor unit. The blades are very sharp.
If the blades get stuck, remove the blender bar from the motor unit
before you remove the ingredients that block the blades.
The hand blender is intended for:
- blending fluids, e.g. dairy products, sauces, fruit juices, soups, mixed
drinks and shakes.
- mixing soft ingredients, e.g. pancake batter or mayonnaise.
- pureeing cooked ingredients, e.g. for making baby food.
1 Attach the blender bar to the motor unit ('click') (Fig. 5).
2 Put the ingredients in the beaker.
See the table for the recommended quantities and processing times.
Blending quantities and processing times
Ingredients Blending quantity
(max.)
Fruits & vegetables 100-200g
Baby food, soups & sauces 100-400ml
Batters 100-500ml
Shakes & mixed drinks 100-1000ml
Note: Always let the appliance cool down to room temperature between
processing cycles.
3 Immerse the blade guard completely in the ingredients to avoid
splashing (Fig. 6).
4 Press and hold the unlock button (1) and then press and hold the
power-on button (2) within 2 seconds (Fig. 7).
Note: If you do not press the power-on button within 2 seconds, the charging
light flashes red and the appliance remains locked. To unlock the appliance,
repeat step 4.
The appliance starts to operate.
,
- Release the unlock button when the appliance starts to operate.
- When you release the power-on button, the appliance switches off.
5 Move the appliance slowly up and down and in circles to blend the
ingredients (Fig. 8).
6 Clean the appliance after use (see chapter 'Cleaning') and then place
it in the protective blade guard.
chopper
Be very careful when you handle the chopper blade units, the blades are
very sharp. Be particularly careful when you remove the blade units from
the chopper bowl, when you empty the chopper bowl and during
cleaning.
Time (max.)
60sec.
60sec.
60sec.
60sec.