Selecting The Application Type; Measurement (Automatic Mode) - BEAUTY ANGEL 770 sun Gebrauchsanweisung

Operation
42/78
3.6

Selecting the application type

Before the session begins, the desired application type must be selected.
There are 3 possible selections:
PURE BEAUTY: Only the Beauty Light lamps are switched on. The sen-

sor is not used for this application.
BEAUTY & SUN: Beauty Light lamps and UV lamps are switched on. The

proportion of UV radiation is up to 30 %. The sensor is used for this ap-
plication.
SUN & BEAUTY: Beauty Light lamps and UV lamps are switched on. The

proportion of the UV radiation is higher than the proportion of the Beauty
Light lamps, depending on the skin type and base tan. The sensor is
used for this application.
– Press the button for the desired type of application.
If the sensor is not used, the device will be operated in the SUN & BEAUTY
programme using the legally prescribed minimum power of the UV lamps (see
function description on page 32).
3.7

Measurement (automatic mode)

If the sensor is not used the device will be operated using the legally pre-
scribed minimum power of the UV lamps (see function description on
page 32).
Please observe the instructions on page 11.
NOTE:
The blood flow of the skin has an effect on the measurement
result. As a result, your physical condition on the day, sport-
ing activities or extreme ambient temperatures can result in
different measurement results.
1st measurement on the forehead
– Hold the sensor to your forehead (not in the centre), press and wait for
the signal tone.
– Please pay attention to the announcements in the Voice Guide.
2nd Measurement on the body
– Place the sensor on the lightest place on the body, for example on the
inside of the upper arm, and press. Wait for the signal tone.
– Please pay attention to the announcements in the Voice Guide.