GYS 062269 Bedienungsanleitung Seite 7

Translation of the original instructions
Protection corresponding to code numbers/letters 7, 9, CH is provided by
the complete protector only if the respective symbols are identical on the lens
and frame.
Maintenance :
- Do not place heavy objects or tools on or in the facepiece to avoid
damage to the filter or face shields.
Mask storage temperatures range from -10°C to +60°C.
- Clean the Optoelectronic Filter with a clean cotton or special lens cloth.
- Regularly clean and change the guard screens.
- Clean the inside and outside of the mask with a neutral detergent-
disinfectant. Do not use solvents.
- Make sure that the sensors and cell are not obstructed by dust or debris.
- We recommend using the mask and visors for 5 years. The length of use
depends on various factors such as type of use, cleaning, storage and
maintenance.
BEFORE WELDING
-Check that the welding helmet is in good condition and headband adjustment.
-Check whether the front cover lens, the front frame and filter are inserted and fixed in place. In case of anomalie, please proceed to
its reconditionning.
-Make sure that the sensors (4) and the cell (2) are not obstructed by dust or debris.
-Make sure that the protection films on both screens are removed.
-Check that the protection level matches your welding processes. Please refer to the following chart to help your choice (cf. welding
process board)
OPERATION
The FIREMAN 3/5-13 TRUE COLOR auto-darkening welding helmet switches from light to dark state when a welding arc is struck. The
auto-darkening welding helmet switches back to the light state when the arc stops.
1 2
7
3
REPLACING THE MASK BATTERY
The opto-electronic filter requires 2 3V lithium batteries (CR2032*2).
Follow the instructions below to change batteries:
- Pull the cover (11) and then remove the battery.
- Place a new battery in position. Polarity «+» must stay visible.
- Put the cover back (11).
- We recommend to replace the battery once a year.
CAUTION
- Recycle used lithium batteries. In Europe, batteries are considered as dangerous waste.
- Do not throw in the bin. To drop off only in collection point for used batteries.
PRECAUTIONS
• The welding helmet is suitable for use with virtually all welding processes except Oxy-Acetylene welding, laser welding and gas
welding.
• Standard protective screens must be installed on both inside and outside surfaces of the module. Failure to use protective screens
may constitute a safety hazard or result in irreparable damage to the module.
FIREMAN 3/5-13 TRUE COLOR
1. Sensitivity control knob
4
2. Delay time control knob
3. LCD protection plate
7
6 4. Solar cell
5. Filter
5
6. Sensors
7. Potentionmeter «Welding-Grinding»
7
EN