Damaging Of The Blank, Block Holder Or Clamping Lever In Case Of Improper Handling - Vhf R5 Originalbetriebsanleitung

R5 – Operation: Preparing jobs
F . 52 – ( ) A
IG A CORRECTLY INSERTED DISC
SLANTED POSITION
NOTICE
Damaging of the blank, block holder or
clamping lever in case of improper
handling
If you let the clamping lever snap against the
blank or block holder, the clamping lever may
damage the blank or block holder and / or the
clamping lever may get damaged.
Do not let the clamping lever snap against the
blank or block holder.
Slowly guide the clamping lever upwards
against the blank or block holder.
8.
Immobilize the blank or block holder by guiding
the clamping lever against it.
9.
To ensure a proper seating, push the blank or
block holder slightly downwards.
10.
Discs: If the disc has been marked for remount-
ing, slightly rotate the disc until the marking lies
in the corresponding opening in the clamping
lever ( Fig. 53 – see below ).

; ( )
B A DISC IN A
Original Operating Instructions: R5
Version: 5/10/2019
F . 53 – T
IG HE MARKING FOR REMOUNTING
THE OPENING IN THE CLAMPING LEVER
The blank or block holder can be loaded into the
working chamber.
EN 41
( )
BLUE CIRCLE LIES IN