Silvercrest SWS 3000 A1 Kurzanleitung Seite 13

˜ Filling quantity
Observe the water gauge
o
maximum filling quantity for water and tea .
Water
Tea
˜ Cleaning and care
m
WARNING! The product shall not be immersed in
water or other liquids . Do not hold the product under
running water .
Always disconnect the product from the mains supply
before cleaning .
Check the product prior to each use for visible signs of
damage .
˜ Cleaning
Do not use any abrasive, aggressive cleaners or hard
brushes to clean the product .
Clean the product with a slightly damp cloth . Use a mild
o
detergent, if necessary .
Rub all parts dry with a clean cloth .
o
˜ Care
Removing calcifications
NOTE: Limescale reduces the efficiency of the product
and increases energy consumption . Check the product
regularly for limescale deposits .
1 . Fill the water kettle with a vinegar solution (5 to
[ 4 ]
15 %) .
2 . Press the button
[ 8 ]
automatically .
3 . Keep the solution in the water kettle overnight . Discard
the solution on the next day .
4 . Fill the water kettle with clear water up to the
Water Max mark on the water gauge
water .
5 . After boiling: Discard the water to remove any remaining
scale and vinegar .
6 . Rinse the interior of the water kettle thoroughly with tap
water .
regarding the minimum/
11 ] [
Min. Max.
0 .5 l 1 .7 l
0 .5 l 1 .2 l
. Wait for the product to turn off
. Boil the
11 ] [
Cleaning the strainer
D
1 . Remove the lid .
[ 2 ]
2 . Gently pull on the clip of the strainer
strainer (Fig . D) .
3 . Rinse the strainer with fresh water .
NOTE: If scale deposits have set on the strainer, soak the
strainer for a few hours in a water-vinegar solution (5 to
15 %) .
4 . Rinse the strainer with fresh water .
5 . Insert the strainer with its top edge into the upper rim of
the water kettle .
4 ] [
E
6 . Press the strainer firmly into position (Fig . E) .
13
to release the
13 ] [
13
GB 13