Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. Battery Capacity (display at charging and discharging)
The K-Werk
includes a charge level indicator
1
the number, colour and light mode of the active LED's:
Number of
Active LED's
Colour
alight
5
blue
5
5
blue
4
4
blue
4
4
blue
3
3
blue
3
3
blue
2
2
blue
2
2
blue
1
1
blue
1
1
red
1
1
red
0
28
. The charge level is shown in steps of 10% by way of
5
Light Mode
Charge
level
flashing
0
100%
1
90%
0
80%
1
70%
0
60%
1
50%
0
40%
1
30%
0
20%
0
10%
1
5%
As soon as the red LED on the K-Werk
1
is alight (charge level ≤10%), then it is necessary to
re-charge. Once the indicator LED lights red, appr. 1 hr run time remains when using in combi-
nation with the IQ-XM Speed. This value is valid for the lowest light level on dipped beam mode,
connected to the light connection
2
. High beam cannot then be activated. If the red indicator
LED is flashing, any head light connected to the light connection
mode. The light will get succesisvly dimmer over the following 60 mins until it finally goes out.
This is done in a controlled way to prevent deep discharge.
If the red LED is alight and a blue LED is flashing on the charge level indicator
automatic protective power down has been activated.
Refer to point 8.2 Protective function for K-Werk.
8.1. K-Werk Charge times
The charging of the K-Werk by means of the dynamo connection
factors, such as speed driven, specific dynamo in use and devices connected and in consuming
energy. The K-Werk can accept a max charge current of 2A.
With no devices attached, charge time at 15 Km/h (minimum)
Charging via USB with proprietary Busch+Müller charger
Charging via third party USB chargers
If third party charging devices are used, the any warranty is no longer valid.
2
will be in "safe-way-home"
, then an
5
3
depends on a number of
appr 10 hours
appr 5.5 hours
up to 14 hours
29
Werbung
