Heart Rate Monitor; Battery Information - Bryton Rider 530 Bedienungsanleitung

Heart Rate Monitor

Item
Physical size
Weight
Water Resistance
Transmission range
Battery life
Operating temperature
Radio frequency/protocol
Accuracy may be degraded by poor sensor contact, electrical interference, and receiver
distance from the transmitter.

Battery Information

Heart Rate Monitor and Cadence Sensor Battery
The heart rate monitor/cadence sensor contains a user-replaceable CR2032 battery.
To replace the battery:
1. Locate the circular battery cover on the back of the heart rate
monitor/cadence sensor.
2. Use a coin to twist the cover counter-clockwise so the arrow on
the cover points to OPEN.
3. Remove the cover and battery. Wait for 30 seconds.
battery chamber.
5. Use a coin to twist the cover clockwise so the arrow on the cover
points to CLOSE.
NOTE:
When installing a new battery, if the battery is not placed with the positive connector
Be careful not to damage or lose the O-ring gasket on the cover.
Contact your local waste disposal department to properly dispose of used batteries.
32 Appendix
Description
67~100 x 26 x 15 mm
14 g (sensor) / 35g (strap)
20 m
5 m
1 hour per day for 24 months
o o
5 C ~ 40 C
2.4GHz / Dynastream ANT+ Sport wireless
communications protocol