Closing Pegs For Unused Locating Holes - Wnt Mng Rund Montage- Und Betriebsanleitung

_________________________________________________________________________________________
√
Note: for 4-fold clamping, it is preferable to use MNG rectangular
√
The clamping direction for 3 or more MNG round units must always be from
one side since otherwise the clamping forces would counter each other.

4.3 Closing pegs for unused locating holes

Closing pegs to protect the unused locating bolt holes. (see 8.3 Accessories)
By operating the clamping screw (approx. 4 turns) the clamping bolt is pushed into
the locking groove of the closing peg.
Important: only lightly tighten clamping screw.
www.wnt.com XND.00016.002_A - 04/2018
X
24