Residual Risk; Replacing The Locating Bolts; Notes On Clamping Technology; Duties Of The Organisation In Charge - Wnt Mng Rund Montage- Und Betriebsanleitung

_________________________________________________________________________________________

2.3 Residual risk

The user is responsible for applying the correct workpiece tension.
New clampings have to be carefully checked by qualified personnel with relevant training.
One always needs to allow for the risk that the workpiece may be dislodged, even when the
clamping device is functioning correctly; this is due to the different processing force, wrong
manipulation of the milling machine etc.
Protective devices are to be attached to the processing machine that will protect the operator
from any tool or workpiece parts that may be ejected.
It is mandatory that operators and others in the proximity of the processing machine wear
protective goggles.
The clamping device must not be used in any way that impairs its function and operational safety.

2.3.1 Replacing the locating bolts

Damage may result if locating bolts are insufficiently tightened!
For further information, refer to section 4 "Operation".

2.3.2 Notes on clamping technology

The operator is responsible for ensuring that the clamping geometry and clamping forces are
suitable for the intended processing.
We recommend that clamping be carried out with a torque wrench in order to achieve
consistant clamping results. The clamping forces can only be achieved if the clamping
device functions correctly and the workpiece is correctly held in the device.
Regular servicing and cleaning in accordance with the operating instructions is mandatory
in order to ensure correct function.

2.4 Duties of the organisation in charge

The organisation in charge of the device undertakes to only allow operatives to work on the device:
 who are familiar with the basic health and safety regulations and regulations for the
prevention of accidents.
 who have completed appropriate instruction for working with the machine.
 who have read and understood these operating instructions.
The requirements of the EC Directive 2007/30/EC on the use of work machinery must be
complied with.
www.wnt.com XND.00016.002_A - 04/2018 18