Operation (Standard Operation); Clamping / Aligning; On Machine Table With T-Slots; On Machine Table With Ø12 / M12 Grid Holes, 50 Mm Grid - Wnt Mng Rund Montage- Und Betriebsanleitung

_________________________________________________________________________________________
4

Operation (standard operation)

4.1 Clamping / aligning

4.1.1 On machine table with T-slots

4.1.2 On machine table with Ø12 / M12 grid holes, 50 mm grid
www.wnt.com
Alignment "longitudinally" in T-slot
Use appropriate size of alignment and centering
set for the T-slot (see MNG accessories)
Fit the flat slot nut -a- under the MNG round by
pegging with the centering bushes -b- and fix it with
the cylinder screw -c- .
The flat slot nut can be fitted at any 90°angle beneath
the base plate.
Place the unit on machine table, alignment "across"
with the help of a dial gauge or similar.
Fix the unit with two cylinder screws -d- and
T-slot nuts through the MNG round.
Additional fixing with round brackets -e- is
recommended. (see MNG accessories)
Position and fix unit with two fitting
screws -f- Ø12 f7 / M12 (see MNG accessories),
diagonally into the positioning holes in the base
plate.
Insert additional screws, using normal cylinder
screws -g- M12, DIN 912, through the two other
fixing holes.
Max. torque: 70 Nm
XND.00016.002_A - 04/2018 22