Declarations Of Conformity - Ruris Rtx600 Bedienungsanleitung

EN
Loosen the screws. Remove the air filter cover.
Check the filter and replace it if necessary.
Water cooling system
Check the nozzles on the disc guard and the water filter and clean them if necessary.
9.2 Troubleshooting
Problem
Cutter does not
start
The disc spins
at idle
The disc does
not rotate in
the while the
engine is
accelerating
The cutter has
no power then
When It is
accelerated
Vibration
levels are
too big
The
temperature
cutter is too
high
Manufacturer: SC RURIS IMPEX SRL
Blvd. Decebal, no. 111, Administrative Building, Craiova, Dolj, Romania
Goal. 0351 464 632, www.ruris.ro, info@ruris.ro
Authorized representative: Eng. Stroe Marius Catalin – General Manager
14
CAUSE pOSSIBLE
started steps unsound
The switch is not switched in the ON
position
The cutter is out of fuel
The spark plug is fouled and
Presents oil deposits
High idle speed
Defective clutch
belt too LOW or BAD
Defective clutch
The disc is mounted incorrectly
Air filter clogged
Fuel filter clogged
hole the fuel tank is blocked
Disc mounted incorrect
Defective disc
Defective vibration damping
elements
The air intake grilles are blocked
belt glide
clutch slips / is defective

10. DECLARATIONS OF CONFORMITY

DECLARATION OF CONFORMITY CE
Method SOLVING
REVIEW chapter ' Start '
Toggle the switch to
ON position
Load cutter
The spark plug is cleaned with a brush or is
replaced
Adjust rev
Contact an authorized RURIS service
Squeeze or Substitutes belt
Contact an authorized RURIS service
adapt your disc correct
Check the air filter and replace it if
It is necessary
Substitutes the fuel filter
Contact an authorized RURIS service
Check if the cutting disc is mounted correct
and does not present signs of damage .
Change disc
Contact an authorized RURIS service
Clean air intake / cooling grilles of the
cutter
Check the belt / tighten it if It is necessary
Check belt / tension it if necessary