Maintenance And Troubleshooting - Ruris Rtx600 Bedienungsanleitung

EN
4. Place the cutter on a solid flat surface. Insert your right foot into the
sole of the cutter and with your left hand firmly grasp the handling
handle.
CAREFUL! Make sure that the disc does not come into contact with
foreign bodies or other objects when starting. With your right hand pull
gently until you feel resistance and the starter rope is taut, then in one
motion pull steadily. Do not let go of the handle, but bring it back to its
original position with your hand. Repeat the operation on the cutter
starter until you hear the first start sign. At this point stop operating the
starter. Push the shock back to its original position. Repeat the starter
actuation in the same manner until the cutter starts to accelerate. After a few seconds, operate the
throttle briefly to stabilize the idle.
When the engine is warm, the shock lever and the priming pump are no longer actuated.
To stop the engine, turn the ON/OFF switch to the OFF(0) position, the stop position.
The images are informative, the supplier reserves the right to make structural and functional
changes to the machine presented in this manual.

9. MAINTENANCE AND TROUBLESHOOTING

9.1 Maintenance
Exterior cleaning -Clean the machine daily using a clean cloth after finishing work.
Cooling air intake - Clean the cooling air intake when necessary.
spark
If the cutter has low power, starts hard, or idles poorly, check the
spark plug first.
Make sure the spark plug plug is not damaged.
If the spark plug is dirty, clean it and at the same time check that the
gap between the electrodes is 0.5 mm.
Tensioning the transmission belt
The drive belt is enclosed and well protected from dust and dirt.
Loosen the three screws (A) by turning them one turn
counterclockwise.
12