Fuel Supply; Commissioning - Ruris Rtx600 Bedienungsanleitung

EN
Rotate the bearing housing in the opposite direction and reassemble the
stopper.
ATTENTION!
1. Gasoline is flammable. Avoid open flames near fuel. Stop the engine and let it cool before
refueling.
2. RURIS engines are lubricated with special 2TT -MAX oil made for air-cooled 2-stroke gasoline
engines. If you do not use an API TC class oil or a higher class, during the warranty period, you risk
losing the warranty.
The recommended mixture ratio: 1l gasoline + 25 ml oil 2 times SEE. Gas emissions are controlled by
fundamental engine parameters and components (eg: carburetion, ignition timing, muffler)
3. These engines are certified to run on unleaded gasoline.
4. Make sure you use gasoline with a minimum octane number of 95.
5. Unleaded gasoline is recommended to reduce air pollution in order to protect the environment.
6. Poor quality gasoline or oils can damage the engine's sealing rings, intake manifolds, piston,
rings, cylinder, or fuel tank.
Petrol liters 1 2 3 4 5
Ml oil for 2-stroke engines 25 50 75 100 125
▪
measure exactly the amount of gasoline and for oil, we recommend using a graduated syringe.
▪
homogenization is done by stirring the mixture in a fuel container without impurities.
▪
put the petrol in a clean fuel container.
▪
pour in all the oil and mix well.
▪
place a clear label on the outside of the container to avoid confusion with other containers.
Hold the cutter with both hands and maintain a firm grip
while working. The right hand should be on the back
handle and the left hand on the front handle. Never use
the cutter with only one hand.
Stand parallel to the cutting disc. Avoid sitting straight
the event of a kickback, the cutter will move in the plane
cutting disc.
8

7. FUEL SUPPLY

Recommended mixing rate
Blending scheme

8. COMMISSIONING

back. In
of the