Ruris RTX600 Bedienungsanleitung Seite 27

EN
If the kickback area is used for cutting, the reactive force
causes the disc to climb into the cut. Do not use the recoil
zone. Use the lower dial of the disc to avoid kickback.
Avoiding recoil
The workpiece must always be supported so that the cut remains open. When the cut opens, there is no
recoil. If the cut closes and catches the disc, there is always a risk of kickback.
Switching
1.Make sure the ON/OFF switch is in the ON(I) position, the start
position.
2. Actuate the shock lever and the shock flap will close
3. Constantly press the priming pump until it fills with fuel
and returns to the tank (about 6 times).
11