Installation; Operation - Eurolite Rubberlight Led Rl4 Bedienungsanleitung

INSTALLATION

Unpack the lighting chain.
Unroll the tube, connect it with the mains and wait some minutes until it has warmed up. Disconnect from
mains and start with the installation.
In order to design the desired patterns, draw the form onto the surface and attach the mounting-clips. For
free forms, you can use a stable wire in order to bring the tube into the desired form. Use tie straps in order
to connect the tube with the wire. You can fix the tie straps with the suction cups.
The minimum bending radius is 3 cm.
The tube must never be shortened.
How to connect the tube to the power supply:
Connect the device to the mains with the power-plug. Make sure that the outlet is in a dry area.
After the installation, the power supply cable, the plug and the connector must be free of any tractive forces
and rotary forces.
The lighting chain must never be covered with any object.

OPERATION

After you connected the lighting chain to the mains, the LEDs start burning. Via the integrated controller, you
can choose among fourteen different programs using the Press-button:
1. Running - smooth transitions.
2. Waterfall - flowing transitions.
3. Flash, 2 LED-Groups
4. Dark group running - a group of "unlit" LEDs moves backwards and forwards along the lighting chain.
5. Waterfall, fast
6. Forward and reverse runnung – Forward and backward chaser..
7. Forward and reverse running – with 3 LED-groups, 1, 2, 3 / 4, 5, 6 / 7, 8, 9.
8. Forward "curtain-open" - LEDs switch on from left to right, all LEDs on. Then the LEDs switch off one
by one from the center toward the two sides.
9. Snowfall
10. Waterfall, middle
11. Chasing
12. Groups of LEDs switch on one after the other until the entire lighting chain is illuminated.
13. Static Light (no memory function).
14. Static Light (no memory function).
For article 50510822. red, without programm 13 and 14.
10/11 00062463.DOC, Version 1.1