Yamaha HTR-6230 Bedienungsanleitung Seite 21

Notes
• During the automatic setup procedure, do not perform any
operation on this unit.
• We recommend that you get out of the room while this unit is in the
auto setup procedure. It takes approximately 3 minutes for this unit
to complete the auto setup procedure.
6
When all measurements are completed
successfully, "FINISH" appears on the front
panel display.
The result of the automatic setup for each speaker
appears in order on the front panel display.
The distance between the speaker
and the listening position
FL: 3.3m
Speaker
FL/FR: Front left/right
C: Center
SL/SR: Surround left/right
SW: Subwoofer
y
• To display the result of the automatic setup again, press lk / n
repeatedly.
Notes
• If you select "RELOAD" in step 4, no test tones are output.
• If an error occurs during the "AUTO:CHECK" procedure, the
setup procedure is canceled and an error screen appears. For
details, see "If an error screen appears" on page 17.
• When this unit detects potential problems during the "AUTO
SETUP" procedure, "WARNING" and the warning messages
appear after this unit displays the result of the automatic setup. For
details, refer to the "AUTO SETUP" section in "Troubleshooting"
on page 41.
• The distance measurement result may be longer than the actual
distance depending on the characteristics of your subwoofer.
7
Press ol / h to select "SET" or "CANCEL."
Choice
SET*
Confirms the "AUTO SETUP" results.
CANCEL
Cancels the "AUTO SETUP" results.
8
Press oENTER to confirm your selection.
"AUTO SETUP" appears on the front panel display.
9
Press kMENU to exit from "SET MENU."
10
Disconnect the optimizer microphone from
this unit.
The optimizer microphone is sensitive to heat. Keep it
away from direct sunlight and do not place it on top
of this unit.
y
• If you change speakers, speaker positions, or the layout of your
listening environment, run "AUTO SETUP" again to recalibrate
your system.
• When you want to check the result of the automatic setup in detail
or manually adjust the parameters, use "MANUAL SETUP" (see
page 32).
+2
The result of the
adjustment of the
volume level
Function
Optimizing the speaker setting for your listening room (YPAO)
■
If an error screen appears
If this unit detects the potential problems, an error
message appears on the front panel display during the
automatic setup.
For details about each error message, see the "AUTO
SETUP" section in "Troubleshooting" on page 41.
After a few seconds later, the following choices appear.
Press ol / h to select "RETRY" or "EXIT" and then
press oENTER.
Choice
RETRY*
Starts the "AUTO SETUP" again.
EXIT
Exits from the "AUTO SETUP" procedure.
■
If "WARNING" appears
When this unit detects potential problems during the
automatic setup procedure, "WARNING" appears on the
front panel display after result of each speaker. Check the
warning messages to correct your speaker settings.
Note
• Warnings differ from errors in that warnings do not cancel the automatic
setup procedure.
Press on to display the detailed information
about the warning.
The detailed information about the warning is displayed
and the indicators of inapplicable speakers blink on the
front panel display.
PHASE REVERSED
y
• For details about each warning message, see the "AUTO SETUP" section
in "Troubleshooting" on page 41.
Function
LFE
L C R
SL SR
Flashes
17
En