BE QUIET! SFX POWER 3 Bedienungsanleitung Seite 6

Before using the power supply, allow it to warm up to room temperature for one
hour to prevent condensation accumulating in the power supply.
3. COMPATIBILITY
The be quiet! SFX Power 3 / TFX Power 3 series power supplies are compatible
with all recent popular power supply and motherboard specifications such as:
∙ Intel SFX12V Version 3.42
Intel TFX12V Version 2.52
∙ ATX System Design Guide Version 2.2 and Version 2.1
∙ BTX Version 1.0a
∙ E-ATX Server Dual Motherboards via 8-pin Connector (SFX3-450W)
∙ Intel C6/C7 Status for the new processor generation
∙ Energy Star 8.0 guidelines
∙ ErP guidelines
4. INSTALLING YOUR NEW POWER SUPPLY
Please read „Safety instructions" before you begin the installation.
Note: You will need a screwdriver to fit the power supply in your PC. Only use the
screws provided with the power supply because they have the correct thread.
Caution: Only use the supplied cable set. Using cables that were not included (e.g.
cables of older power supply unit series) may lead to defects!
First remove your old power supply. To do so, proceed as follows:
∙ Carefully disconnect your PC from any power sources and unplug all cables
connected to the PC.
∙ Open the PC case, taking care to follow the manufacturer's instructions.
∙ Disconnect all plugs from the motherboard and all other components, such as
FDDs, HDDs, or optical drives. Make sure that there are no plugs from the old
power supply connected to any of the components.
∙ Now remove the screws at the rear of the power supply and carefully pull the
power supply out of the PC case. Take special care that no cables get caught in
the components and damage them.
Fitting your new be quiet! SFX Power 3 / TFX Power 3 power supply:
∙ Place the new power supply in the space provided in the PC case and connect
to the rear panel using the four screws provided. Do not use excessive force.
6
https://tm.by
Интернет-магазин TM.by