BURG WATCHER ENTRY Fingerprint Montageanleitung Und Bedienungsanleitung Seite 37

Submenu create user with Fingerprint
(This function is only active with ENTRY Fingerprint and with the
ENTRY KP FP keypad)
• Activate the keypad using the
• Then press FUNC, ‚Menu / Code Change' is displayed
• Scroll using the 2 key till reaching the ‚Administrator menu'
• Confirm with . The "Create User" menu item appears
• Confirm with
• Scroll using the 2 key till reaching the "Create User: Fingerprint" item
• Confirm with
• Enter the administrator code in order to acquire the authorisation for
programming
• "Register finger" is displayed
• Move the finger to be registered several times centrally over the sensor (the
number of moves is indicated on the display)
• "User.xxxx.FP successfully programmed" appears in the display
Create User with sE key submenu:
• Switch on the keypad using the key
• Then press FUNC; "Menu / Code Change" appears
• Scroll using the 2 key until the Administrator menu appears
• Confirm your selection using
• The "Create User" menu item appears
• Confirm your selection using
• Scroll using the 2 key until "Create: sE key" appears
• Confirm your selection using
• Enter the administrator code in order to acquire the authorisation for
programming
• Manipulate the sE Key in the vicinity of the cylinder
• "User.xxxx.KY created" appears in the display
Assigning a Code submenu
Using this function, you have the option to subsequently assign a code to an
already existing user. For this purpose, proceed as follows:
• Switch on the keypad using the key
• Then press FUNC – "Menu/Code Change" appears
• Scroll using the 2 key until the Administrator menu appears
• Confirm your selection using
• Scroll with the 2 key until "Assign" appears
• Confirm your selection using
• Scroll with the 2 key until "Create User: Code" appears
• Confirm your selection using
• Enter the administrator code in order to acquire the authorisation for
programming
• Scroll to the user to whom you want to assign a code and confirm using
• Enter a 6-digit code and confirm 2 × using
• "Data has been saved" appears in the display
secuENTRY
key
English | 39