Changing The Rod - Wohler VIS 2000 Handbuch

3. Changing the rod

3. Changing or installing the rod
For changing the rod, you first have to pull out the rod completely. Now disconnect the
connection between rod and viper and take out the rod (if necessary, move the basket
slightly). Turn the viper clockwise almost one rotation back up to the stop position.
Guide the jack of the new rod through the loop to the clutch socket of the viper and
connect them. Now you can roll up the viper counterclockwise. While rolling up the
rod, pay attention that it coils smooth around the basket. If the rod coils one-sided, it
may derail out of the basket.
Fix the free-wheel-bracket as described in point 2.2.5.
If you insert a rod with another legth, you will also have to change the parameters.
Keep the button of the winder fixed, while starting the monitor and release the button
after 3 seconds. The parameters will be shown in the first line. Move the cursor to the
right with a double-click and change the number with a simple click. Store the values
by clicking 3 seconds without interruption. After that the new parameters and the
lenght will be displayed.
If you install rods or cables with other lenghts, you will have to change the parameters
acording to the following table:
Type
lenth
Cable winder 20m
Cable winder 30m
Camera viper 42 20m
Camera viper 42 30m
Camera viper 36 20m
Camera viper 36 30m
24 Hotline:+49 29 53 / 73 211
running meters external dimension
695 24
1042 27
382 42
573 42
561 36
868 36
Fax: +49 29 53 / 73 250
Camera Viper VIS 2000
internal dim.
19
19
38
36
32
30