wallas 1300 Betriebs- Und Einbauanweisungen Seite 11

Voor onderdelen of advies ga naar www.hagerbv.nl of bel 0566-622209
Classic paraffin 1300
Old fuel – water in
fuel
Long storage can cause
water condence which
produces wax in Paraffin oil.
As this will till up fuel pumps
and burner wicks, it is
suggested that 3 – 5% of
Iso-Propyl alcohol is mixed
with the fuel. Filled up fuel
pumps and burners can be
cleaned by running the
heater in cold state for 10-20
minutes with Iso-Propyl
alcohol. For this remove the
fuel pipe from the tank, start
the heater and allow it to run
for 10 minutes without fuel
before using the alcohol.
Use only Iso-Propyl /
Propanol based carboretor
spiritus, - not Etyl / Methyl
based qualities.
Fuel quality
The fuel must be premium
grade paraffin with a
Smoke-Point of 35 mm,
which should conform to BS
2869. Suitable types are
"Pink" and "Blue" in U.K.,
Esso Blue in Skandinavia
and in Europe generally the
Esso Exxsol D 60 (D180 –
220).
Voor onderdelen of advies ga naar www.hagerbv.nl of bel 0566-622209
Water intake through
exhaust head
The exhaust heads 2466
(cookers) and 2460
(heaters) will, opened, leak
water in the heater when
submerged or flushed.
The penetrating water can
then damage the heaters
electronics or blower motor.
Limited water penetration in
a hot running heater may,
however, not be harmful as
such water is immediately
vaporized and expelled.
When closed these exhaust
heads do not take water in
the heater under above
circumstances, provided:
- that the exhaust head is
properly closed.
- that the telescope inner
tube slide joint of the exhaust
head 2460 is tightened by
Silicon grease. The greasing
is made in factory but it can
be removed in mounting –
must be checked. New
Silicon grease is available
9
IMPORTANT TO OBSERVE
from Wallas-Marin
representatives or Wallas-
Marin.
- that the gaskets in the
exhaust head are not
defective and that the take
through deck joint will not
leak.
Observe, that the exhaust
heads are not pressure
water tight when closed and
will not stand continuous
subnerging or overflooding
without some leaking.
The water intake can be
reduced through raising the
exhaust head 30 mm from
the deck with the collar 2068
(for 2460) or alternatively
100 mm with extension base
or 2069 (for 2460 or 2466)
or by using the through hull
board fittings 1066 (for
cookers) or 2467 (for
heaters).
490130C