Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Section
III: Backwash
Backwash
and Rinsing must be performed to prepare the pump for its first use and to wash the sand.
CAUTION:
DO
NOT
1 Press
down
on the
2. Insert the plug into a residual current device, and run the sand filter for 3-5 minutes, or until the
water
runs
clear.
3 Switch
off the
sand
4. Switch on the sand filter and run the sand filter for 1 min. This circulates water backwards
the
sand
filter
and
5. Svitch
off the
sand
6. Top up pool water.
IMPORTANT:
This procedure
the sand filter immediately
DO
NOT
DRY
RUN
Section
'V: Complete
Connect
the
Second
NOTE:
It is imperative to check that the hydraulic
connectors
are
not closed.
NOTE:
Ensure
the
Control
function.
Assembly
1.Detach the Hose(25) from Port D.
2.Attach the Hose(25) to the Control Valve's
the threaded locking ri ningto position.
3.Connect the other end of Hose (25) to the pool's Inlet A
4.0pen
the connection
NOTE:
You can refer to pool manual for connection
valve's
installation
instructions.
Section
V: Sand
Filter
1 . Nowthe sand filter is ready for use. Set the Control Valve to the Filter function.
NOTE: To prevent the risk of electrical shock dry any excess water from yourself
and
the
sand
filter.
IMPORTANT:
Before operation,
base and connected
2. Switch
on the
sand
NOTE:
The sand filter has now staned its filtering cycle.
returning
to the pool and take note of the filter pressure on Pressure Gauge.
Generally,
the recommended
0.56Bar (8.0PSl) when it is running.
Sand
Filter
Maintenance
CAUTION:
You must ensure the sand filter is swtched
before any maintenance begins or severe risk of injury or death exists. As dirt
builds up in the sand filter, the pressure
increase. When the Pressure Gauge is 0.56Bar (8.0PSl)
flowto
the pool is too low, it is time to clean the sand. To clean the sand bed,
follow all instructions
Backvesh
and
Rinsing.
and
Rinsing
DRY
RUN
THE
Control
Valve
handle
filter
and
set the
Control
drains
water
out
Pot
filter.
Set
the
Control
removes water from the pool, which you'll need to replace. Switch off
if water levels near the pool's Inlet and Outlet valves.
THE
SAND
FILTER.
Sand
Filter
Installation
Hose
Valve
is set to the
valve.
Operation
make sure the tank is placed steadily on its
correctly to the pump.
filter
to run
it.
sand filter pressure is less than
reading on Pressure Gauge WII
outlined previously
in Section
SAND
FILTER
and
rotate
to the
Backwash
Valve
to the
Rinse
D.
Valve
to the
Closed
Closed
Pott A; screw
25
Check that water is
off and unplugged
or higher, or water
II and
Section
function
function.
function
.
25
Ill:
through
Watt level
2 in:h
Liw
Werbung
