Bestway FLOWCLEAR 58366 Gebrauchsanleitung Seite 6

HOSE ADAPTOR FUNCTIONS
22
Pool with Valves (03.2cm)
1) Connect the Adaptors
2) Attach the Hoses
3) Attach the Hoses to the Sand filter by pressing the
hose fitting on the pump port. Screwthe
corresponding letters on both the pool and the Sand filter match (A to A, B to B).
4) Remove the Stopper Plugs from the pool's inlet and outlet valves and insert with the Debris Screens (26).
5) With the Hoses and Debris Screens (26) in position, tighten the Hose Clamps (23).
GARDEN HOSE ADAPTOR
1 . Assemble the garden hose adaptor(11).
2. Screw the garden hose adaptor(1 1) onto pott D of the sand filte.
3. Attach garden hose to the garden hose adaptor(1 1)
NOTE:
1.Garden hose adaptor(11) can be used for draining yonr pooll and can only be assembled to port D
of the sand filter.
2.Always switch off and unplug the sand filter before assembling the garden hose adaptor(1 1),
and set the control valve to Closed position.
3.Ensure the washer
Section I: Assembly
1 .Carefully remove all components
ensure nothing is damaged.
notify the retailer from where the equipment was purch ased.
2.The sand filter should be placed on solid, level ground, preferably
concrete slab. Position
Valve are accessible
3.EN60335-2-41 TEST standard
fixed on ground or a ceftain pedestal made of wood or concrete before use to
prevent the sand filter from accidental falling.
Fully assembled sand filter will exceed 18kg. The mounting holes should be 8mm in diameter and
spaced 86mm apart. Use two bolts and nuts Wth a maximum of 8mm in diameter to fasten the
sand filter to the pedestal.
Load pool-grade filter
NOTE: Use only special pool-grade
0.45-0.85mm, approximately one 35kg bag should suffice.
If you do not use the recommended
sand filter may damaged,
NOTE: To avoid damaging the Skimmer vhen adding sand, pour some water into the Bottom Tank to
submerse the Skimmer
NOTE: SAND NOT
(22) to the Hose.
to the correspondingletters
FUNCTIONS
is in position before assembling
(You will need a Phillips screwdriver.)
from the package and check to
If equipment
the sand filter so the
for operation, setvicing
requires the sand filter must be vertically
sand.
filter sand, free of all limestone
size of filter sand, filtering performance
thereby voiding the warranty.
on the Hub.
INCLUDED.
P6132
on the pool.
threaded locking rings into position; ensure the
2
the garden hose adaptor(1 1).
is damaged, immediately
Ports and Control
and Wnterizing.
1.2 inch<
23
3
a
08cm
or clay: #20 Silica sand
will be reduced and the
86cm