Always install the device via all fixation holes.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.
Before taking into operation for the first time, the installation has to be approved by an expert!
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
Attention: A booster must be installed after every eight LED tubes.
Connection of the devices
P1 = 2-pin socket
P2 = 2-pin plug
Ω
P3 = 120
. termination plug (end piece)
Attention: The power supply must be interrupted between P1 and P2 every four tubes before and after the
booster. A booster must be installed after every eight LED tubes
DANGER TO LIFE!
International
L
N
19/23
5192861A_V_1_1.DOC