Atlas Copco ETPSL21-07-i06-PS Produktinformation Seite 9

ETPSL21-07-i06-PS EN Installation
• Security check that the connection is correct by pulling, pushing and turning
the cable connector (there should be no movement).
The tool has a built in electronic memory chip that will transmit the torque
transducer calibration value and angle pulses to the POWER FOCUS/drive
unit. Any changes made of these values in the POWER FOCUS while the
tool is connected will be stored in the tool memory.
© Atlas Copco Industrial Technique AB - 9836 813900 00 9