Temperature Adjustment - AEG SANTO 80368-5 KGL Benutzerinformation

5. Set the freezer temperature to -18 °C or colder (see section: "Tempera-
ture Adjustment").
Do not load freezer with goods until a temperature of -18 °C has been rea-
ched, or until the red warning indicator light has gone out..

Temperature Adjustment

With the individual temperature setting buttons the desired temperatures
in the refrigerator and in the freezer compartment can be adjusted inde-
pendently of one another.
1. Press either the „+" (WARMER) or „-" (COLDER) button for the refriger-
ator or freezer compartment .
The temperature display switches over and the DESIRED temperature cur-
rently set flashes on the temperature display.
2. To adjust to a warmer temperature, press the „+" (WARMER) button. To
adjust to a colder temperature, press the „-" (COLDER) button. The changed
setting is immediately displayed on the temperature display.
Each time the button is pressed the temperature is adjusted by 1 °C.
Adjustable temperature range for the freezer compartment:
-15 °C to -24 °C.
Adjustable temperature range for the refrigerator compartment:
+3 °C to +8 °C, (HOLIDAY: +14 °C )
Note: +5 °C for the refrigerator compartment and -18 °C for the freezer
compartment should be considered cold enough as a storage temperature.
3. When the buttons are not further pressed after an adjustment has been
made, after a short period (approx. 5 sec.) the temperature display switches
over and again displays the ACTUAL temperature in the refrigerator com-
partment. The display changes from flashing to illuminated numbers.
When the setting is changed, the compressor does not start immediately if
automatic defrosting is currently taking place.
The display lighting switches itself on when any button is touched. If no
button is pressed, the display lighting switches itself off after approx. 1
minute.
Important! Please check regularly on the warning display and on the tem-
perature display that the storage temperature is being maintained.
Tip:
The appliance setting cannot be changed when the mains plug is pulled out
or there is no power supply.
When reconnected to the mains supply, the appliance takes on the state it
had at the time of the interruption to the power supply.
Downloaded from Fridge-Manual.com Manuals
42