ALTENBURGER ELECTRONIC DALI Dim/Converter Control NV Bedienungsanleitung Seite 10

With a multi-switch at the DALI Dim/Converter Control the following steps can be selected:
Position 1: Analog control with switch contact:
1...10V to DALI with ON/OFF with the switch contact
ON/OFF switching with the switch contact (relays/switch) at [T1]
•
- Contact close = ON; contact open = OFF
Control of the lighting brightness via an analog voltage input [AS]
•
- the voltage (1..10V) is the switch ON or the control value
Motion part of the multi-sensor: automatic switch ON after recognition of a motion. Contact at [T1]
•
closed.
Light part at the multi-sensor: automatic switch ON if daylight falls below the set light level and
•
contact [T1] closed.
Multi-Sensor motion and constant light control:
•
- automatic switch ON if daylight falls below the set light level to be kept constant,
however only if motion is detected. Contact at [T1] closed.
- no automatic switch ON at motion detection if daylight exceeds the set light level.
Position 2: Analog control without switch contact:
1...10V to DALI with ON/OFF with analog control voltage
ON/OFF switching with analog control voltage at [AS]
•
- voltage > 1,4 V = ON, voltage < 1,4 V = OFF
Control of the brightness with the analog voltage input [AS]
•
- the voltage > 1,4 V is the switch ON or the control value
Motion sensor: automatic switch ON at motion detection. Voltage at [AS] >1,4 V
•
Light sensor: automatic switch ON if daylight falls below the set light level. Voltage at [AS] > 1,4 V
•
Multi-Sensor motion and constant light control:
•
- automatic switch ON if daylight falls below the set light level, however only if motion is
detected. Voltage at [AS] > 1,4 V
- no automatic switch ON at motion detection if daylight exceeds the set light level.
Position 3: 1-pushbutton switch dim-function:
ON/OFF switching with a pushbutton (normally open contact) at [T1]
•
- short push: ON/OFF
Control of the lighting brightness with the pushbutton (normally open contact) at [T1]
•
- continuously pressing the button: Brighter-Darker control
Storage of light level to be kept constant at [T1]
•
- Double push: last set light level is stored as constant light level (lighting blinks 1x)
- the stored light level is the switch ON and controlled light level
Motion detector: automatic switch ON at motion
•
Light sensor: automatic switch ON if daylight falls below the set light level
•
Multi-Sensor motion and constant light control:
•
- automatic switch ON if daylight falls below the set light level, however only if motion is recognized.
- no automatic switch ON at motion detection if daylight exceeds the set light level
Position 4: 2-pushbutton switch dim-function:
ON/OFF with a pushbutton (normally open contact) at [T1]
•
- short push: ON, continuous push: BRIGHTER
OFF/DARKER with pushbutton (normally open contact) at [T2]
•
- short push: OFF, continuous push: DARKER
Storage of light level to be kept constant at [T1/T2]
•
- simultaneously and continuously pressing both buttons [T1/T2] (> 3secs.)
Signalizes the storage of the light level to be kept constant by 1xblinking of the lighting
- the stored value is the switch ON and the control value
Motion detector: automatic switch ON at motion
•
Light sensor: automatic switch ON if daylight falls below the set light level
•
Multi-Sensor motion and constant light control:
•
- automatic switch ON if daylight falls below the set light level, however only if motion is recognized
- no automatic switch ON at motion detection if daylight exceeds the set light level
DALI Dim/Converter Control NV 10/16