dewert okin RF1058 Kurzanleitung Seite 4

Quick Reference Guide to RF1058 / CU170
b. Manuel teach-in
The system must be connected to the power supply.
 Quickly press the Reset/Pairing button twice on the CU170 (button 6).
The floor lighting and the green pairing LED will illuminate. The CU170 is
now in pairing mode for 120 seconds, which is divided as follows: During
the first 60 seconds, an RF1058 can be discovered (the teach-in). During
the next 60 seconds, a Bluetooth
 The floor lighting and the blue LED are illuminated during this teach-in
phase for the RF1058.
RF1058: Simultaneously press buttons 1 and 19.
A successful pairing will be acknowledged.
 The floor lighting will switch off after the teach-in process for the RF1058
is finished. The blue LED for pairing with a Bluetooth
flashing.
 The blue LED switches off when the Bluetooth
out or when the device has connected successfully. A successful pairing
will be acknowledged.

If, during the RF1058's teach-in process, you press any button on an
already paired RF1058, then it switches to the Bluetooth
 If the RF1058 or a Bluetooth
phase, then this pairing mode is automatically ended. The floor lighting
and the blue LED switch off.
 When operating a system in parallel, you must execute the teach-in
processes for the CU170s sequentially. First, connect the CU170 to the
power supply. Then execute the teach-in process for the first RF1058 or
® device. Then execute the teach-in for the second device.
Bluetooth
Only commission one system at a time. Never configure multiple
Note!
systems simultaneously.
2. Locking or enabling the RF1058
Press and hold button 18 for about three seconds: this will either enable or
lock the RF1058.
A successful pairing will be acknowledged.
03.04.2017
device can be discovered.
®
® device starts
pairing process has timed
®
teach-in mode.
®
device is discovered during the pairing
®
Id-No. 84625(c)
3. Adjusting the intensity of the massage
To turn the massage function (head and foot end) on or off, press
button 11 on the RF1058.
If the massage function is turned off, it can be activated by pressing
button 10, 12, 13 or 15.
If the massage function is turned on, it can be deactivated, starting
from the lowest intensity, by pressing button 13 or 15.
The massage intensity is changed through 4 steps each time one of
the buttons 10, 12, 13 or 15 is pressed.
Press the WAVE button 14 to switch between the three interval levels.
This is then indicated by the LEDs above the massage function on the
RF1058.
4. Execute a reference movement
The referencing must be execute in the following scenarios:
 The initial commissioning
 A change in hardware
 After the battery-powered electrical reset function has been
execute.
The CU170 has a positional feedback feature. A referencing
movement must first be carried out before this feature can function
properly. Press and hold the reset/pairing button (6) on the CU170
until the end position has been reached.
A successful pairing will be acknowledged.
5. Saving the memory positions
You can save two different memory positions on the buttons "ZGRAV
/ TV" as follows:
 Move to the desired position using buttons 1 to 9.
 Press and hold button 16 (SET) for one second.
 Within three seconds, press button 20 (ZGRAV) or button 21 (TV)
in order to save the position, this is confirmed by a "beep" signal.
 The desired position is now saved on buttons 20 or 21.
You can overwrite the saved memory position at any time by repeating
this process.
4 / 12