dewert okin RF1058 Kurzanleitung Seite 3

Quick Reference Guide to RF1058 / CU170
RF1058
2
1 3
5
6
4
9
7
11
12
10
14
13 15
17
18
16
19
21
20
a
c
b
03.04.2017
Button Function
1 Drive M1 up (head)
2 Drive M3 up (lift)
3 Drive M2 up (foot)
4 Drive M1 down (head)
5 Drive M3 down (lift)
6 Drive M2 down (foot)
7 Drive M4 up (tilt)
9 Drive M4 down (tilt)
10 Head massage higher level
11 Massage on/off
12 Foot massage higher level
13 Head massage lower level
14 Massage wave
15 Foot massage lower level
16 Set memory
17 Under Bed Light on/off
18 Child safety lock on/off
19 Position Flat
20 Memory position Zero G
21 Memory position TV
1 + 19 Pairing System 1
3 + 19 Pairing System 2
13 + 15 Press + Release
16 + 19 Press + Hold
16 + 19 Reset memory position
LED Massage function
a slow
b medium
c fast
Id-No. 84625(c)
The floor lighting will blink twice and a "peep" tone will
Acknowledgement:
sound to signal the successful completion of the step.
1. Teach-in for the RF1058 or app
To start using the RF1058 with a Bluetooth
CU170 must first be established.
In order to use a Bluetooth ® device (a smart phone or tablet) with your system,
you will first need to download and install the "OKIN" app for your device.
a. Automatic teach-in
 Insert the power plug into a power outlet. The CU170 will be in pairing mode
for 120sec which is divided as follows: During the first 60sec, an RF1058
can be discovered (the teach-in). During the next 60sec, a Bluetooth
device can be discovered.
 The floor lighting and the blue LED are illuminated during this teach-in phase
for the RF1058.
RF1058: Simultaneously press buttons 1 and 19.
A successful pairing will be acknowledged.
 The floor lighting will switch off after the teach-in process for the RF1058 is
finished. The blue LED for pairing with a Bluetooth
 The blue LED switches off when the Bluetooth
out or when the device has connected successfully. A successful pairing will
be acknowledged.

If, during the RF1058 teach-in process, you press any button on an already
paired RF1058, then it switches to the Bluetooth
 If the RF1058 or a Bluetooth
then this pairing mode is automatically ended. The floor lighting and the
blue LED switch off.
 Repeat the automatic teach-in process. First, remove the plug from the
power supply. Then wait 60sec and insert the plug back into the power
supply. You can now start the new teach-in process.
 When operating a system in parallel, you must execute the teach-in
processes for the CU170s sequentially. First, connect the CU170 to the
power supply. Then execute the teach-in process for the first RF1058 or
Bluetooth ® device. Then execute the teach-in for the second device.
Only commission one system at a time. Never configure multiple
Note!
systems simultaneously
® device, the wireless link with the
® device starts flashing.
® pairing process has timed
teach-in mode.
®
device is discovered during the pairing phase,
®
®
3 / 12