Tchibo CAFISSIMO Bedienungsanleitung Seite 31

Limescale builds up inside the machine during normal use.
The machine automatically indicates that it needs descaling when
the service indicator light
If you do not descale the machine regularly or do not perform the
descaling procedure correctly, limescale residue is left behind inside
the machine. This causes limescale deposits to build up more quickly
and will ultimately stop your machine from working properly. In this
case repair is not covered by your warranty!
We recommend using Saeco CA6700 descaling solution
(sold separately), whose formula has been designed
to respect the technical specifications of this machine, thus
ensuring its ongoing performance and its safe and risk-free
use. The descaling solution is to be disposed of according to
the manufacturer's instructions and/or the regulations in force
in the country of use. The Durgol descaling solution also
respects the technical specifications of the machine.
Warning! Never drink the descaling solution or any
products dispensed until the cycle has been
completed. Never use vinegar as a descaling solution.
1- Turn the machine off by pressing the On/Off button
2- Ensure there is no capsule in the capsule compartment and close
the lever.
3- Remove and empty the water tank, the drip tray, the used
capsule drawer and the waste water drawer.
4- Pour the required amount of descaling solution into the water
tank and fill it with fresh water up to the MAX level.
5- Reinsert the water tank, the drip tray, the used capsule drawer
and the waste water drawer.
6- Remove the drip tray.
7- Place a container with a minimum capacity of 1 litre under the
coffee dispensing spout.
8- Simultaneously press the espresso
(yellow) buttons for 3 seconds until the service indicator
light (orange) is continuously lit or flashing, depending on
the status of the machine before starting the descaling process.
Then release both buttons.
9- The machine will indicate that the descaling mode is activated
when the espresso button
10- Press the espresso button
descaling solution. The machine dispenses the descaling solution
at regular intervals via the coffee dispensing spout. The espresso
button (white) flashes throughout this descaling cycle.
(orange) is constantly lit.
(white) and caffè crema
(white) is continuously lit.
(white) to start dispensing the
The cycle can be temporarily suspended, for example
to empty the container, by pressing the filter coffee
button (blue). Press it again to continue with the
descaling process.
11- Once the machine has dispensed all of the descaling solution,
the service indicator light
crema button
12- Remove and empty the container filled with the dispensed
solution and the waste water drawer. Reinsert the waste water
drawer and put the container back under the coffee dispensing
spout.
13- Remove the water tank and rinse it under running water, then fill
it up to the MAX level with fresh drinking water. Place the water
tank back in the machine.
14- Press the caffè crema button
cycle.
The machine will dispense the water from the coffee dispensing
spout. During this cycle the caffè crema button
flash.
15- When the rinsing cycle has finished, all the buttons will flash a few
times and the machine will turn off.
.
If you did not fill the water tank up to the MAX level
for rinsing, the service indicator light
will start flashing at the end of the rinsing cycle. Fill the water
tank to the MAX level and repeat step 14.
16- Empty the container into which the rinsing water was dispensed.
17- Empty the drip tray and the waste water drawer.
18- Now your machine is ready to brew coffee again.
The next time you switch on the machine, the service
indicator light
the water tank is empty. Fill the water tank, insert a capsule,
close the lever and press the corresponding coffee button.
The service indicator light
machine will dispense the beverage into your cup.
If you have switched off the machine during the
descaling or rinsing cycle by unplugging the power
cord, you need to finish the descaling process before you can
brew coffee. Plug the power cord back in. Press the On/Off
button to switch on the machine. If the espresso button
(white) is lit, continue the descaling process by pressing
the espresso button
thereafter. If the caffè crema button
continue the rinsing cycle by pressing the caffè crema button
(yellow) and follow steps 15 to 18 thereafter.
(orange) flashes and the caffè
(yellow) is continuously lit.
(yellow) to start the rinsing
(orange) will flash to indicate that
(orange) will stop flashing. The
(white) and follow steps 11 to 18
(yellow) is lit,
• 21 •
(yellow) will
(orange)