Sharp YC-QS302A Bedienungsanleitung Seite 15

CONTROL PANEL
1. DIGITAL DISPLAY – Cooking time, power,
indicators and clock time are displayed.
2. 10 SECONDS, 1 MINUTE, 10 MINUTES –
Use to set time of cooking or the clock.
3. AUTO MENU keys – Press to select auto
cooking menu. (Refer to page 16 for
advice on use).
4. START/QUICK START – (Page 14).
5. MICROWAVE POWER – Press to select
microwave power level. (Page 14).
6. GRILL – Press to set grill cooking
program. (Page 15).
7. MICROWAVE+GRILL – Press to set
microwave and grill combination cooking
program. (Page 15).
8. UP – Press to set food weight or
servings.
9. DOWN – Press to set food weight or
servings.
10. STOP/ECO – Press once to temporarily
stop cooking, or twice to cancel cooking
altogether. Use to set power saving mode. (Page 17).
11. CHILD LOCK – (Page 18).
12. TIME/SET CLOCK – Use to set clock time. Use to set timer function. (Page 14).
BEFORE USING THE OVEN
When the oven rst plugged in, beep will sound and the display will show "1:00". Note that the clock does not have to
be set for the oven to operate correctly. To set the clock, follow the instructions in the "Setting the Clock" section of
this User Manual.
When new, the very rst time the grill and/or convection is used, smoke and odors will be given o . To avoid this
happening when food is being cooked, use the grill and convection function without food for approx. 20 minutes.
• After opening and closing the door, the oven will enter the standby mode. If no buttons are press within 1 minute,
the display will remain on and the buttons will not operate. To enter standby mode again, open and close the door.
• During cooking, if the STOP/ECO button is pressed once, the cooking cycle will be paused. To restart cooking press
the START/QUICK START button. If the STOP/ECO button is pressed twice, cooking will be canceled.
• When programming the oven for a particular function and there is a pause between button presses of more than 30
seconds the oven will return to the standby mode.
• When a cooking cycle is completed, the display will show "End" and a tone will be heard every two minutes until a
button is pressed or the door is opened.
1
2
3
4
8
10
EN – 13 EN – 13
1
2
3
5
4
6
9
8
11
10
12
EN
5
7
9
11
12