Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Electrical Connection
• Connect the Hood to the Mains power
sup-ply, inserting a two-pole Switch
with a con-tact aperture of at least 3
mm.
• Remove the Metal grease fi lters (see
par. on "Maintenance") and make sure
that the power supply Cable is proper-
ly inserted in the Suction fan socket.
• Take the wires indicated in fi g.1 and
pass them through the slot formed on
the galva-nized diffuser support, as
shown in fi g.2.
• Position the fi nishing plug 27 over the
housing in the diffuser support, fi xing
it us-ing a screw 12e (2.9 x 9.5) and
applying the 2 cable clamp elements
26 as indicated in fi gs. 3 and 4.
• Connect the Controls Connector fi g.
5.
• Connect the Lighting Connector fi g.
6.
• Store both the Connectors in the
Protective box 24 and close it with 2
Screws 12e (2.9 x 9.5), provided.
• Remove the protective fi lm from the
dou-ble-sided adhesive on the con-
nection box, and fi x it inside the motor
compartment fi g. 7.
electrolux 49
Installation
1
2
4
3
6
5
7
EN
Werbung
